Changing A Parameter - Siemens LOGO! Series Manual

If no parameter can be set, LOGO! displays the following:
No Param
Press ESC
3. Select the desired parameter:
LOGO! displays a parameter in a separate window.
4. To change a parameter, select it and press the OK key.

4.1.3 Changing a parameter

To change a parameter, you first have to select it (see "Selecting a parame-
ter").
You change the value of the parameter in the same way as you entered it
in progamming mode:
1. Move the cursor to the point at which you want to make the change:
2. Change the value:
3. Accept the value:
B01:T
T = 01:00m
T = 00:00m
a
Change the value: Y or B
You cannot change the unit of the delay time for the parameter T in para-
meterization mode. This is only possible in programming mode.
LOGO! manual
EWA 4NEB 712 6006-02
No parameter can be changed:
ESC returns you to the parametrization
menu
or
Move: A or "
Finished: OK
Parameterizing LOGO!
or
or
OK
69