Table of Contents
Advertisement
POLISHINg/HONINg A bLADE
After the sharpening blade/tool operation, the leather stropping wheel (A) Fig.14
can be used to remove burrs for a smooth, razor sharp edge. Follow these steps:
NOTE: Do not attempt to hone scissors using the leather stropping wheel.
Remove burrs if any from the scissor blades using a scrap piece of wood.
1. Disconnect power cord from power source.
2. Install the universal support in the horizontal position. Use the angle guide to
determine blade angle. Install blade in square edge jig, install jig on universal
support. Using angle gauge, adjust jig and the universal support position as
necessary. Refer to "Setting The Angle Using The Angle Guide" in this manual.
3. Make sure the stropping wheel has been properly prepared before attempting
to polish/hone. Refer to "Preparing The Stropping Wheel" in this manual.
4. Turn the Wet/Dry Sharpener on, placing the switch in the Forward direction (WITH the direction of the rotation of the grinding/sharpening
wheel). Move the blade back and forth evenly along the leather wheel. Do not apply excessive force, allow the leather stropping wheel to do
the work.
CAUTION: WHEN USING THE POLISHING/HONING LEATHER STROPPING WHEEL. The universal support CAN ONLY be installed in the
horizontal position as shown in Fig.14. Attempting the polish/hone a blade AGAINST the direction of the rotation of the polishing wheel, or with
the universal support in the vertical position, WILL SEVERELY DAMAgE THE POLISHINg/HONINg LEATHER STROPPINg WHEEL.
TROUbLESHOOTINg
grinding noise from drive system.
Insufficient grease in gearing. Solution: After some time the gears wear, some noise is normal. If noise is excessive: Turn machine OFF, unplug
power cord. Remove the gear cover, lubricate gears using general or white-lithium grease.
grinding/sharpening wheel not rotating smoothly or evenly.
Grinding/sharpening wheel is not properly installed. Solution: Re-install the grinding/sharpening wheel.
Grinding/sharpening wheel is worn out or imbalanced. Solution: Replace grinding/sharpening wheel.
Machine spindle is not straight. Solution: Stop using machine and call your local service centre for repair information.
Stropping wheel lowered performance.
Improper wheel preparation (lack of oil or honing compound). Solution: Prepare the stropping wheel according to instructions.
Damaged. Solution: Replace wheel.
Wavy finish on the surface of a workpiece.
Tool is not held in place firmly. Solution: Make sure you are holding the tool or jig firmly.
Grinding/sharpening wheel face is uneven. Solution: Dress grinding/sharpening wheel according to instructions.
FREqUENT INSPECTION AND MAINTENANCE
The Wet/Dry Sharpener should be inspected and maintained frequently. Check and make sure the power cord, internal wires, plug and switch
are in good condition. Check the condition of the grinding/sharpening wheel before
every use. Service should be done by a qualified service technician using identical
replacement parts.
CLEANINg WATER TRAY WITH WATER
After operating your Wet/Dry Sharpener, the water tray will have accumulated
material from hand tools and grinding/sharpening wheel. It is important to keep the
water tray clean using water to clean it.
LUbRICATION
Check the gearbox monthly and add a small amount of general or white-lithium
grease if necessary. Access the gearbox gears by removing 3 pan head screws
and the gearbox cover (A) Fig.15 as shown.
OPERATION & MAINTENANCE
FIgURE 14
FIgURE 15
Advertisement
Table of Contents
