Table of Contents
Advertisement
IAR Embedded WorkBench Session Startup
IAR Embedded WorkBench Session
Startup
It is assumed that the IAR Embedded WorkBench software is installed
and running on your PC.
1. Navigate to the IAR Embedded WorkBench environment via the
Start menu.
Note that IAR Embedded WorkBench is not connected to the tar-
get board.
2. Choose File > Open >Workspace to open a workspace for the proj-
ect to download and debug.
3. Choose Project > Options.
The General Options, Target page appears.
4. In Processor variant, ensure Device is AnalogDevices
ADSP-CM40z-X_Y, where X is the SRAM size in KB and Y is the
internal flash size in KB of the part on the target board.
On the Analog Devices ADSP-CM403F EZ-KIT Lite, SRAM size
is 384 KB, and internal flash size is 2048 KB.
1-6
ADSP-CM403F EZ-KIT Lite Evaluation System Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the ADSP-CM403F EZ-KIT Lite and is the answer not in the manual?
Questions and answers