Siemens SIMATIC NET CP 343-2 Manual page 37

Table 3-1 shows the relevant bits of the CTT slaves.
Table 3-1
Slave in the Type, IO.ID.ID2
example
(see figure)
Slave 1A CTT2, S−7.5.5
Slave 2A CTT2, S−7.A.5
Slave 3A CTT2, S−B.A.5
Slave 4A CTT3, S−7.A.7
Slave 5A CTT3, S−7.A.A
Slave 6A CTT4, S−7.A.8
Slave 7A CTT4, S−7.A.9
Slave 8A, 9A, CTT5, S−6.0.x
10A, 11A
)
* Bit Q2.7 is not shown but can be used.
Note
Slaves with IO code 6 and ID code 0 occupy several AS-i addresses. The IO and
ID code specified by the vendor must be configured for each occupied AS-i ad-
dress.
CP 343−2 / CP 343−2 P AS−Interface Master
Release 08/2008
C79000−G8976−C149−04
Relevant bits Non-relevant bits
I0.0...I0.1 I0.2...I0.3
Q0.2...Q0.3 Q0.0...Q0.1
I1.4...I1.5 I1.6...I1.7
Q1.6 Q1.4...Q1.5
− All bits irrelevant. Data access using
data record 140...147
I2.4...I2.7 −
)
Q2.4...Q2.7 * −
− All bits irrelevant. Data access using
data record 140...147
I3.4...I3.7
Q3.6 Q3.4, Q3.5
− All bits irrelevant. Data access using
data record 140...147
− All bits irrelevant. Data access using
data record 140...147
3 Configuration with STEP 7
37