Siemens SIMATIC NET CP 343-2 Manual page 33

Standard AS-i Slave
The AS-i standard slave can only be placed at an AS-i address in the A area. This
address is then no longer available in the B area.
1) For AS−i slaves that do not support the ID1/ID2
codes, the values F (hexadecimal) must be
entered.
CP 343−2 / CP 343−2 P AS−Interface Master
Release 08/2008
C79000−G8976−C149−04
3 Configuration with STEP 7
Enter the following vendor information for
the AS-i slaves in this area:
S
I/O configuration: standardized
meaning;
S
ID code: standardized meaning;
S
ID1/2 code: Extended ID code as of
AS-i Specification 2.1
As an option, start-up
parameters can be permitted
here;
Whether this parameter can
be used depends on the
slave type.
1)
.
33