Datalogic Magellan 8300 Technical Manual page 44

NOTE
Rear Lift
Handle
2-28
3. Rotate the Interior Lift Handle up as shown in
hook the fingers of both hands in the lift handles indicated. DO
NOT attempt to lift the unit using the plastic edges, scale frame, or
any features other than the lift handles.
4. Lower the unit into the counter opening, ensuring that none of the
cables are pinched, pierced or crimped.
5. Re-install the Platter and verify that it is flush or just below flush
with the countertop. This is necessary to provide smooth scanning
from either direction. Make adjustments as needed to align the plat-
ter with the counter by moving support rails up or down, or con-
sider installing screws in positions that will allow their use in
adjusting the unit's position.
Failure to install a scanner/scale in a stable and level position will inhibit
weighing, calibration and zeroing operations. The platter MUST make unob-
structed contact with all of its supports for proper weighing operation.
6. Once installation is complete, proceed with the
Mode procedures that follow.
Figure 2-23. Using the Lift Handles
Figure 2-23
Scale Diagnostic
Interior Lift Handle
Magellan
and
®
8300/8400