Datalogic Magellan 8300 Technical Manual page 48

Error
Probable Cause
Code
0
Configuration
Blinking
1 Configuration Error
2 Interface Board
3 Motor
4
Horizontal Laser
5
Vertical Laser
6 Digital Board
7 Scale
8 Remote Display
A Control Button Stuck
B Hardware ID
C Scale Calibration
E CPLD ID
Decimal
3.3 V Present
Point
a. If only one laser is non-functional, the scanner may continue to work (this is a configurable feature);
however, the 7-segment display will show the error code indicating the failed laser. If both lasers have
failed, the 7-segment display will display either a 4 or a 5, and the scanner will cease to function until
serviced. No alternate blinking of lamps will occur if only one laser has failed.
3-4
Table 3-1. Error Codes
No POS interface has been selected (Null interface). See
Interface Type
bar codes.
See Chapter 5,
scanner using programming bar codes.
Unplug unit and call technical support personnel.
Unplug unit and call technical support personnel.
a
Call technical support personnel.
a
Call technical support personnel.
Unplug unit and call technical support personnel.
See the topic
identification and corrective actions.
Connect the Remote Display. If necessary, replace display or cable.
Alternatively, you can disable the Remote Display using the program-
ming procedures described in
Check to see if either of the buttons is stuck; free it if possible. If neither
button is stuck, call technical support personnel.
Call technical support personnel.
Calibrate scale or call technical support personnel.
Call technical support personnel.
If not lit, call technical support personnel
Corrective Action
to select the required interface using programming
Programming, for details about configuring the
Scale Error Reporting
Chapter
Chapter 5,
in this chapter for problem
5.
®
Magellan 8300/8400