Table of Contents
Advertisement
Industrial Electronic Devices
M-BUS
By Pressing the "M-Bus" button from the main window for SW67056 (Fig. 2) the window "M-Bus Network" appears (Fig. 4).
In the section "Nodes" it is possible to create the nodes of M-Bus line:
In the field "Description" it is possible to write a short description of the node.
S
N
(M-B
ECTION
ODES
US NODES
In order to create a new node it is necessary to
select which address use, selecting
or
"Secondary
ID", to makes the requests and
then insert the "Primary Address" (from 1 to 250)
or the Secondary Address" (from 0 to 99999999)
of M-Bus device.
If the field
"Node
State" is checked, the Status
byte of the M-Bus node is mapped into a BACnet
Object.
If the field
"Identification
the Identification Number of the M-Bus node is
mapped into a BACnet Object;
In the field
"Swap Identification
possible
to
select
the
Identification Number. If swap isn't necessary you
have to select "None"; otherwise see the section
"Swap Identification" (page 31) of this document
for select the swap mode.
If
the
field
"Convert
Identification
Num." is checked, the converter
converts the Identification Number that is normally
expressed in BCD in a Integer value.
If the field
"Send
SND_NKE" is checked, the
converter sends the "SND_NKE" frame to start the
communication.
ADFweb.com S.r.l.
):
"Primary
ID"
Number" is checked,
Num." it is
swap
mode
of
the
BCD
in
Integer
User Manual M-Bus Master / BACnet Slave
Document code: MN67056_ENG
Figure 4: "M-Bus Network" window
Revision 1.200
Page 19 of 39
Hide quick links:
Advertisement
Table of Contents
