Overview Functions - Tecnosicurezza DigiTech User Instructions

DigiTech
Pre-setup & Configurations
When the lock is in pre-setup mode and connected with the keypad for the first time:
• lock can be simply opened by pressing the button 1. When the bolt is open, the output
connector BAT is enabled;
• only the following options are allowed: Test mode, Language selection,
PC Link, Events check, Time and date view, System information view, Contrast
adjustment.
Through the PC connection and the software DigiTech Setup, the lock can be set according
different configurations, involving the number of users, the dual mode opening and the
Manager management.
User properties and default codes
Users can be set for opening with code only, code + Dallas key or with Dallas key only. It is also
possible to set a dual mode opening: in this case, entering the two users codes is required to
open the lock.
Default codes are:
Manager: 01-123456.
Users from 02 to 29: 02-020202, 03-030303.....and so on. They always open with time delay if
set.
Override user 30: 30-303030. He always opens without time delay.
This user manual describes the standard programming. According such programming and unless
different requests while ordering the product, an opening can be performed by entering single
users codes (no dual mode) and without time delay. Thus, the user manual must be adapted
according the configuration selected.
It is strongly recommended to change the default codes before using the lock.

Overview functions

Lock opening
After entering an opening code, it is possible to open the lock within 3 seconds. It's no necessary
instead with motorized locks: in this case indeed, the motor moves the bolt which remains in
opening position for about 8 seconds before returning in closing position. In the manual closing
version instead, the bolt can be closed by pressing
Penalty
Four consecutive wrong codes initiate a four minutes penalty time. During this period, LCD
shows the message " LOCK PENALTY" and no operation is allowed.
IU_DigiTech_04
key for few seconds.
User instructions
7 of 16