Tecnosicurezza Pulse Pro User Instructions

Pulse Pro
User instructions
Dallas key
In the event that the user is composed of "code + Dallas key", before or after entering the code, the Dallas key must be
placed on the appropriate Dallas key reader.
Override user
The override users open without waiting the time delay. In the default programming they are set in dual code opening but,
upon request, the single opening mode can also be set.
Silent alarm
It is activated by increasing or decreasing the last digit by one number when entering the opening code.
Penalty
After four attempts to enter an incorrect code, the lock starts a 4-minute delay period. Each attempt to enter the code
within the 4 minutes delay period restarts the count.
Low battery warning
A long beep during opening indicates a low battery level.
Replace immediately the low battery with a new Alkaline battery.
Sound signals
A double beep normally indicates a correct operation. A long beep indicates an incorrect operation and the end of the
operation itself.
Recommendations
Do not use easily identifiable codes such as 123456, dates of birth or other personal information.
Opening
(It is recommended to change the factory code before use and to safely store the new code)
Enter the opening code (default Manager code 60-123456).
If the code is correct, the keypad will beep twice.
If programmed, the time delay count starts. The LED flashes every 2 seconds.
A beep every 2 seconds indicates the end of the time delay count.
Enter the opening code. The keypad beeps twice.
Open the safe door within 4 seconds.
Dual code opening
(It is recommended to change the factory code before use and to safely store the new code)
Enter the opening code (default Manager code 60-123456).
If the code is correct, the keypad will beep twice.
If programmed, the time delay count starts. The LED flashes every 2 seconds.
A beep every 2 seconds indicates the end of the time delay count.
Enter both opening codes . The keypad beeps twice.
Open the safe door within 4 seconds.
Change code
(Safely store the new code and perform various opening / closing tests before closing the safe door)
To be performed with the door open!
Press and hold until the double beep. The LED remains on.
Enter the ID of the user whose code is to be changed.
Enter the old code.
Enter the new code.
Confirm the new code.
Perform various opening / closing tests before closing the safe door.
Default codes
Manager 6 0 - 1 2 3 4 5 6 + Optional Dallas key
User 2 0 2 - 0 2 0 2 0 2 + Optional Dallas key
User 3 0 3 - 0 3 0 3 0 3 + Optional Dallas key
User x x x – x x x x x x + Optional Dallas key
IU_PulsePro_easy_01_eng