Table of Contents
Advertisement
U3022AH10
Source Signal Path Insertion Loss Test
Connect the RF Flex cables to the Front Panel Test port and Source IN access port indicated in
Table 20
below. Check that the results are similar to
Source Signal Path Test Instructions
Table 20
Path
RF Path Description
#
Odd Ports
1
Source OUT to Port 3
Source OUT to Port 5
2
Source OUT to Port 7
3
Source OUT to Port 9
4
Source OUT to Port 11
5
Even Ports
6
Source OUT to Port 4
Source OUT to Port 6
7
Source OUT to Port 8
8
Source OUT to Port 10
9
Source OUT to Port 12
10
1. Use the Source IN port associated with this group of test ports.
2. Standard model source control codes.
Figure 61
Source OUT to Ports 3-12 Path Response
U3022AH10 User's and Service Guide
Figure 61
Control Mode Entry
<address>.<data>
1
0.1 (0.113)
2
0.2 (0.114)
0.3 (0.115)
0.4 (0.116)
0.5 (0.117)
16.1 (16.113)
16.2 (16.114)
16.3 (16.115)
16.4 (16.116)
16.5 (16.117)
Troubleshooting the Test Set
below.
Insertion Loss
Path Components
(Typical)
P3 CPLR, S10
Figure 61
P5 CPLR, S10
P7 CPLR, S10
P9 CPLR, S10
P11 CPLR, S10
P4 CPLR, S20
Figure 61
P6 CPLR, S20
P8 CPLR, S20
P10 CPLR, S20
P12 CPLR, S20
81
Advertisement
Table of Contents
