Table of Contents
Advertisement
NetAtlas Enterprise 1.00 User's Guide
2 To view the port status of a switch choose a switch from the list located on the left-hand
side of the screen.
Figure 50 Status: Port Status
The following table describes the labels in this screen.
Table 18 Status: Port Status
LABEL
Port
Link Speed
State
PD
TxPkts
RxPkts
Errors
Polling
Close
67
DESCRIPTION
This identifies the Ethernet port.
This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or 1000M
for 1000Mbps) and the duplex (F for full duplex or H for half). It also shows the cable
type (Copper or Fiber) for the combo ports.
This field displays the STP state of the port. See the Spanning Tree Protocol
chapter for details on STP port states.
This field displays the power device (PD) module status on the switch. If Not
Supported is displayed, the switch does not have a PD.
This field displays On if the switch has a PD and it is in use.
This field displays Of if the switch has a PD, but it is not in use.
This field shows the number of transmitted frames on this port.
This field shows the number of received frames on this port.
This field shows the number of received errors on this port.
The text box displays how often (in seconds) this screen refreshes. You may
change the refresh interval by typing a new number in the text box and then clicking
the Apply button.
Click Close to close the screen.
Chapter 5 Status
Advertisement
Table of Contents
