Table of Contents
Advertisement
This chapter shows you how to access a switch via Telnet or web configurator directly through
the EMS. You may need to do this to test the switch network connection for example.
8.1 Accessing the switch
Access the switch remotely via Telnet or web browser.
Note: When you access a switch via Telnet or the web configurator, you CANNOT
make any changes to that switch using the EMS.
8.1.1 Telnet
Telnet is the login and terminal emulation protocol common on the Internet and in UNIX
environments. It operates over TCP/IP networks. Its primary function is to allow users to log
into remote host systems.
The administrator uses Telnet from a computer on a remote network to access the switch. You
can use remote Telnet access as shown next.
1 Select a switch from the list of devices shown in the Device List Panel.
2 Click Tool and then Telnet to open a console session for Telnet access to the switch.
3 Type the switch User name and Password to access the switch command line prompt.
Figure 62 Telnet
4 Refer to the switch User's Guide for information on the commands used in this screen.
8.1.2 Web Access
Configure the switch using the web configurator as shown.
1 Select a switch from the list of devices shown in the Device List Panel.
Chapter 8 Tools
NetAtlas Enterprise 1.00 User's Guide
C
H A P T E R
8
Tools
84
Advertisement
Table of Contents
