Kenmore STEP UP Service Manual page 65

11. Disassemble/Assemble Procedures
11-12. Freezer Defrost Sensor and Heater in the Evaporator Assembly
Step
1
2
Pull out the evaporator from 3 hooks on the
back wall.
3
4
□ Remark :
• Do not miss 4 cable ties(2 big, 2 small). They could block two
drain holes and the drain water will overflow into freezer.
To avoid risk of electrical shock that can cause death or severe personal injury,
WARNING
!
disconnect unit from power before servicing unless tests require power.
Description
Remove the
connectors
※ Two D-Sensor
with each
connector
※ One D-Heater
with two
Connectors
Cut the cable
ties and
remove the
defrost
sensors on left
and right side
of Eva.
Cut the cable ties
and remove two
temp fuse covers on
left and right side of
Eva.
※ Follow the reverse order when assembling.
Step
5
6
7
8
Remove the heater from Eva.
Description
Remove two temp
fuses of defrost heater.
Spread out the upper
clamping parts (the left and
right side of Eva) to remove
the pipe of defrost heater.
Bend out the lower clamping
parts (the left and right side
of Eva) to remove the pipe of
defrost heater.
65 / 79