Kenmore STEP UP Service Manual page 55

11. Disassemble/Assemble Procedures
11-2. Water Tank and Cover Vegetable Assembly (continued)
Step
9
10
11
Remove the top hinge cover and disconnect
water tube from the water tube fitting.
12
Remain
Water
In Tank
□ Remark :
• Cutting 5/16" plastic tube can make disassembly from valve easier. But Be careful not to be wet on the floor.
• The water line must be fully inserted into the water tube fitting to prevent water leakage.
To avoid risk of electrical shock that can cause death or severe personal injury,
WARNING
!
disconnect unit from power before servicing unless tests require power.
Description
Separate the fixture to protect
5/16"(the big one) tube from
bending damage.
After removing the water
toward the machine room, put a
large cup on dispenser and
prepare to fill the remain water
in door water line.
Tilt the tank toward
the under right side
and then pull the tank
and tubes out slowly
to remove.
※ Follow the reverse order when assembling.
Water Tank Assembly
(tank + tubes + cover + heater + ...)
Water
Tubes
OUT
IN
5/16" Tube from
machine room
OUT
Water
Tank
IN
¼" Tube from
the top hinge cover
55 / 79