Kenmore STEP UP Service Manual page 30

8. Operation and Functions
8-6. Icemaker in the Icemaker Room (continued)
3) Icemaker Power OFF :
□ How to Start :
Preparation Work
"Lock" Mode OFF
□ How to Proceed :
• Display : LED light of Icemaker will turn off. And "Ice off" icon of the control panel will light up.
• Icemaker stops making ice.
• Dispensing cubed / Crushed Ice doesn't work, even if the dispenser lever is pressed.
□ How to End : same as input to start.
4) Icemaker Test Mode :
□ How to Start :
Preparation Work
-
□ How to Proceed :
• Display : Icemaker LED will flash red.
• Ice type(cubed/crushed) selector works 5 times
• Icemaker motor runs 1 cycle.
(Motor On → Heater On → Water Supply → Motor Off)
□ How to End : by finishing test
5) Icemaker Errors
□ Error Display :
• IM Sensor Error : Error code display and icemaker LED flashing
• IM Heater Error : icemaker LED flashing
□ How to Service :
1) Check the wiring connections in each part and at Main PCB.
2) If normal, change the icemaker to new one.
To avoid risk of electrical shock that can cause death or severe personal injury,
WARNING
!
disconnect unit from power before servicing unless tests require power.
Ice
+
Water
Select
INPUT
Press and hold buttons
for 3sec at once.
INPUT
Press power button of the icemaker
6 times within 3sec.
Test Button,
Icemaker LED
flashing at test mode or
error condition
30 / 79