Promac SY-350V Operating Instructions Manual page 8

The coolant tank platform has been fixed on already. The
following is for your reference.
Insert platform (H) to the interior of the machine stand.
Align the platform holes (i) to the screw holes (i) on the
interior of the machine stand.
Apply an M8x18x2, washer to each of the 2 M8x12
screws.
Secure the platform (H) to the stand.
Use a wrench to unscrew a M20 X 40 hex head screw (J)
from the oil fill hole (J).
Attach the control handle to the head assembly:
Insert the threaded end of the control handle into the gear oil
fill hole (J).
Turn the control handle (L) along the shaft to screw in the
control handle until a tight fit.
Align the handle (L) so that the trigger switch (K) point up.
(Refer to image)
Connect the electric wire with the motor:
Locate the open socket (M) at the side of the electrical box
on the top of the motor.
Plug in the control handle cable into the open socket (M).
Use a wrench to screw in the cable connecter nut (N).
Attach the support roller to the left side of the base:
Place the support roller (P) up next to the machine base.
Align the 2 slots (O) in the base of the support roller with the
matching screw holes on the base of the machine.
Apply an M10 washer for each of 2 M10x25 hex head bolts.
Loosely screw the hex head bolts into the aligned slot (O)
and holes.
Adjust the height of the support roller (P). Place a level
across the mouth of the vise and support roller. If a long
level in not available, use a straight bar or piece of material
then place a small level on top. Raise or lower the support
roller until level.
8