Promac SY-350V Operating Instructions Manual page 7

6.2 Anchoring the machine
Position the machine on a firm and level concrete floor.
Maintain a minimum distance of 800mm from the wall to
rear of the machine.
Anchor the machine to the ground, as shown in the
diagram, using screws and expansion plugs or sunken tie
rods that connect through holes in the base of the stand.
Ensuring that it is sitting level (see picture).
6.3 Assembly and Setup
Positioning the machine
Please follow the instruction bellow when unpacking the
machine from the package.
-Take out the accessory box from the rear for
assembling some parts later.
-Take out the machine from the package to the intended
working location by hoisting with the belts. The load
capacity is about 300kgs at point E.
Method one:
Use a sling. Carefully wrap the sling (E) around the collar
of the moveable jaw and motor mount.
Method two:
Using lift rings. Attach lifting rings to three points on the
base of the machine. Attach a three-point sling with grab
or sling hooks to the lift rings.
Initial Cleaning
Machine is shipped with rustproof oil coating. Clean the rust
proof oil coating from all exposed metal surface. Then apply
oil / grease.
The stand of the cold saw has four mounting holes, two holes
on each side of the stand. The cold saw should be kept level
and rest solidly on the floor.
Please refer to the anchoring section above. When securing
the stand to the floor, apply even torque to the fasteners to
prevent distortion of the stand.
The machine has been fixed on the stand already to use.
Giving the picture by appearing the foxing points for
reference.
Align the four setscrews (G) on the underside of the machine
base to their corresponding holes in the stand.
Direct the setscrews (G) into their matching holes while
lowering the machine onto the stand.
Secure the machine onto the stand using three nuts to the
exposed setscrews.
7