Promac SY-350V Operating Instructions Manual page 14

9.2 Loading the work piece
- Use the vise hand-wheel to open the vise wider than the
width of the work-piece.
- Measure and mark off the length of material desired to
be cut-off.
- Place the work-piece on the flat surface in between the
vise jaws.
- Slide the work-piece across the vise so that the length
mark lines up with the blade or disk.
- Press the work-piece up against the back vise jaw.
- Use the vise hand-wheel to clamp the work-piece.
If repetitive cuts are required for material of the same
width:
- Use the vise hand-wheel to approach the work-piece,
but leave an approximate 5mm gap between the mobile
vise jaw and the work-piece.
- Then use the vise lock lever to clamp and unclamp the
work-piece.
Decrease vibration (workpiece position setting)
The clamping vise can be adjusted forward and backward
to clamp work-piece for various size.
Please be followed the trick as below when loading
(setting) the work-piece position for decreasing the
vibration.
Check the workpiece's center not over the center of blade.
Please see drew A
9.3 Setting cutting length
Setting the cutting length removes the need to repeatedly
measure work-pieces for repetitive cuts of a single length.
- Measure and mark off the length of material desired to
be cut-off.
- Load the work-piece.
- Line up the cut
- Clamp the work-piece.
- Loosen the hex nut at the base of the bar riser (A).
- Slide the bar riser (A) along the long rod (C) so that the tip
of stop bar (B) touches the end of the work-piece.
- Tighten the hex nut at the base of the bar riser (A).
The stop bar in use:
Cut off the first length of work-piece.
Unclamp the work-piece
Slide the work-piece forward until it reaches tip of the stop
bar (A).
Clamp the work-piece.
Then proceed with the operation cycle
9.4 Operation cycle
Set the miter cut angle, if necessary.
Open the vise, if necessary.
Load the work-piece.
Clamp the work-piece.
Adjust the bar stop for cutting length, if necessary.
Check that the main power light is ON (A).
Set the speed (C), read the speed displayed on the window
(H).
Set the coolant switch (B).
14