Assembly - Liko Golvo 9000 Series Instructions For Use Manual

The mobile lift is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The
customer or the user of the mobile lift can help prevent electromagnetic interference by maintaining a minimum distance
between portable and mobile RF communications equipment (transmitters) and the mobile lift as recommended below,
according to the maximum output power of the communications equipment.
Rated maximum output
power of transmitter
(W)
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m)
can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power
rating of the transmitter in watts (W) according to the transmitter manufacturer.
Note 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
Note 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflec-
tion from structures, objects and people.
Before assembly, make sure you have the following parts and tools:
• Lift mast with control box and hand control, sling bar with
latches, 2 M6 screws
• Armrest
• Base, with width adjustment motor
Lock the wheels on the base before starting to assemble the lift.
1. A) Position the lift mast between the two black plastic plugs on
the base cross member.
B) Then push the mast forwards as in the figure above so that
it hooks onto the cross member.
7EN140108 Rev. 4 • 2020
Recommended separation distances between portable and mobile RF
communications equipment and the mobile lift
Separation distance according to frequency of transmitter
150 kHz to 80 MHz
d 1 2 , P
=
0,12
0,38
1,2
3,8
12
A
(m)
80 MHz to 800 MHz
d 1 2 , P
=
0,12
0,38
1,2
3,8
12

Assembly

• Battery
• Tools: 4, 5 mm hex keys
• Bag containing: charger cable, charger connector cable
• Instructions for use
B
2. Screw the two provided M6 screws into the upper
holes on the lift mast.
No screws in the lower holes!
9
800 MHz to 2.7 GHz
d 2 3 , P
=
0,24
0,73
2,3
7,3
23
www.hillrom.com