Table of Contents
Advertisement
Charger information
1. "ON" - lights up green when the charger is connected to mains.
2. "CHARGE" - lights up yellow constantly during charging and will
turn off when charging is completed.
NOTE! Charging a deep discharged Li-ION battery
When charging a deep discharged Li-ION battery the charger will start charging at a low charging rate to protect the battery.
During the low rate charging no indicator will light up.
When the low rate charging is completed the charger will automatically switch to normal charge rate and the "CHARGE"
indicator will light up yellow and will turn off when charging is completed.
Charging with the control box internal charger (standard)
Plug the charger cable into mains (100-240 VAC), see charger information
1 - 2 above. The battery is fully charged after about 6 hours and the
charger disconnects automatically, the yellow "CHARGE" diode turn of.
For maximum battery life, batteries must be charged regularly.
We recommend charging after each use or every night.
Never charge batteries in a wet area!
NOTE! If the charger cable is stretched out it should be replaced to avoid the risk of the cable getting caught and tear.
NOTE! The lift cannot be used when the charger cable is plugged into a wall socket.
NOTE! If the yellow "CHARGE" diode at the control box continuous to be lit after 8 hours, discontinue charging and replace
the battery with a new one.
NOTE! A damaged battery shall be replaced and contact with leaking fluids shall be avoided.
Alternative charging procedures
Alt. A
Wall mounted charger accessory or table charger housing accessory:
Loosen the holder for the charger cable. Remove the battery pack from the control box by loosening the locking device on top
of the battery pack. See chapter "Assembly".
Charger information;
"ON" - lights up green when the charger is connected to mains.
"CHARGE" - lights up yellow constantly during charging and will turn off when charging is completed.
Alt. A. Place the battery pack on the wall mounted charger. Plug the charger cable into mains (100-240 VAC)
check that both "ON" and "CHARGE" on the charger lights up.
Alt. B. Place the battery pack on the charger in the table charger housing. Plug the charger cable into mains (100-240 VAC)
check that both "ON" and "CHARGE" on the charger lights up.
7EN140108 Rev. 4 • 2020
Charging the Battery
ON
CHARGE
Alt. B
CHARGE
18
1.
2.
ON
CHARGE
ON
CHARGE
ON
www.hillrom.com
Hide quick links:
Advertisement
Table of Contents
