Liko Golvo 7000 ES Instruction Manual
Hide thumbs Also See for Golvo 7000 ES:

Advertisement

Golvo 7000 ES/ 7007 ES
Golvo is an electrically powered mobile lift, i.e., both
raising and lowering of the lift arm and width adjust-
ment of the base are done with electric motors.
To ensure maximum safety for caregivers and patients,
Golvo is equipped for both mechanical and electrical
emergency lowering. All Golvo lifts are equipped with
convenient armrests, to assist both the caregiver and
the patient. If needed, the armrests can be folded down
into a support position.
Golvo is also available in a design with an extra low
base; Golvo LowBase™. This model is recommended
In this document, the person being lifted is called the "patient" and the person helping is called the "caregiver".
are triangles used to warn of situations that demand extra care and attention.
IMPORTANT!
Carefully read these instructions and the instructions for the particular lifting accessory being used. Lifting
and transferring patients always presents a potential risk. It is essential to thoroughly understand the content
of these manuals, and that only trained persons use the equipment. If you have questions, please contact
Liko or your local Liko representative.
Product Description
for lifting to and from beds/barrack-beds that have a
ground clearance of 58-110 mm (2.28-4.3 inch.).
Golvo can be used in most lifting situations: for
example, between bed/wheelchair, to/from the toilet,
in bath and shower, to/from the floor, for weighing
patients and for horizontal lifting.
A comprehensive range of accessories are available
for Golvo, including sling bars of different widths,
slings in many sizes and fabrics, and accessories
for ambulation/gait training, static weight-bearing,
weighing patients, and for emergency room use and
horizontal lifting, etc.
Golvo™
Instruction Guide
7EN140102-03
2009-07-03
Applies to the following models:
Golvo 7000 ES
Prod. No. 2000009
Golvo 7007 ES
Prod. No. 2000010
Golvo 7007 LowBase™
Prod. No. 2000061
Golvo 7007 LowBase™
English

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Golvo 7000 ES and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Liko Golvo 7000 ES

  • Page 1 Golvo 7007 ES Prod. No. 2000010 Golvo 7007 LowBase™ Prod. No. 2000061 Golvo 7000 ES/ 7007 ES Golvo 7007 LowBase™ Product Description Golvo is an electrically powered mobile lift, i.e., both for lifting to and from beds/barrack-beds that have a raising and lowering of the lift arm and width adjust- ground clearance of 58-110 mm (2.28-4.3 inch.).
  • Page 2: Table Of Contents

    Never leave a patient unattended in a lifting situation Golvo 7000 ES/7007 ES/7007 LowBase are tested by an accredited testing institute and comply with the require- ments of the directives for medical-technical Class 1 products (MDD 93/42/EEC).
  • Page 3: Definitions

    50-60 Hz, max 400 mA. Sound level: 53 dB Lift motor: 24 V, 6.5 A. Manufactured by Liko with planetary gearing and safety nut (pre- vents excessive wear). This device is built for indoor operation. Motor for width Type B according to the degree of protection adjustment: 24 V, 3.5 A.
  • Page 4: Measurements

    Measurements Golvo 7000 ES/7007 ES Golvo 7007 LowBase™ Maximum load and weight in kg. Measurement in mm. Model Wheel Max. B² B³ H H 1 H 2 Weight Turning diameter load diameter Golvo 7000 ES 75/75 200 1750 1990 1340 540 1120...
  • Page 5: Assembly

    Assembly Before assembly, make sure you have the following parts and tools: • bag containing instruction guide, tag marked • mast with lift arm, motor for lift arm, control box and "Emergency lowering", charger cable and exten- sling bar with bolt and locking nut (M8) sion cable •...
  • Page 6: Assembly

    5. Assemble the sling bar (or other accessory) using M8 6. Connect the cables to the control box as follows: screws and locking nut (enclosed). Make certain to - Cable for hand control to socket number 1. turn the screws 2 mm (0.08 inch.) past the lock func- - Cable for lift motor to socket number 2.
  • Page 7: Disassembly

    Disassembly 1. Start by loosening the sling bar or other accessory mounted on the lift. 2. Loosen the armrest holder as described below: A. Loosen both of the M8 screws on each side of the B. Remove the armrest holder by using two screw- mast.
  • Page 8: Operation

    Operation Operation Operate the lift using the pushbuttons on the hand control. For raising and lowering, press either of the two upper pushbuttons. The direction in which the arrows are point- ing applies when the hand control is held as shown in the illustration.
  • Page 9 Setting the lifting range If you need to move the sling bar closer to the floor, you can do this by using the mechanical lowering device to extend the lift strap. Do not extend the lift strap more than necessary since this also influences the maximum lifting height.
  • Page 10: Transfers From Bed

    Parking the sling bar When the lift is not being used, or when moving an empty lift, the sling bar can be placed in the parking bracket. The parking bracket is intended for use with Universal SlingBar 350, 450 and 600 (all models). Important when using the parking position: Never raise the lift arm while the sling bar is parked in the parking bracket since this might cause personal...
  • Page 11: Charging The Batteries

    Note! The lift does not operate when the charger cable is plugged into a power socket. Old batteries are to be left at the nearest recycling station or given to personnel authorized by Liko. Golvo • 7EN140102-03 w w w . l i k o . com...
  • Page 12: Maximum Load

    300 kg (660 lbs.). In this case, the applicable max. load is 200 kg (440 lbs.) for the total lift system. Study markings on the lift and lifting accessories or contact your Liko representative if you have any questions.
  • Page 13 Q-link See ”Guide to Liko´s Quick-release Hook System”, which can Prod. No. 3156509 be downloaded from our website, www.liko.com, or contact Liko for more information on the advantages and use of the Quick-release Hook system. Standaid Set Prod. No. 2001020...
  • Page 14 Short, max. 70 kg (154 lbs.)/pair Prod. No. 3166512 Short, max. 100 kg (220 lbs.)/pair Prod. No. 3156513. For more information, see instruction guide for Liko MasterVest, mod. 60, 64, or Liko Lift Pants, mod. 92. Leg Protector Leg Protector Set Golvo 7000, grey Prod.
  • Page 15: Simple Troubleshooting

    5. Check that the contact plates of the battery are not defective or broken off. 6. If the lift still does not work satisfactory contact Liko. 1. Check that the emergency stop button Battery charging does not work. is not pushed in (page 8).
  • Page 16: Care And Maintenance

    Repairs and maintenance may only be carried out according to Liko service manual, by personnel authorized by Liko and using original Liko spare parts. Service agreements Liko invites you to sign a service agreement for regular maintenance and testing of your Liko products. Contact your local Liko representative for more information. Transportation and storage During transportation, or when the patient lift is not to be used for some time, the emergency stop button should be pushed in.

This manual is also suitable for:

Golvo 7007 lowbaseGolvo7007 es

Table of Contents

Save PDF