Trip Data Storage And Transfer; My:car - Jeep Renegade Owner's Handbook Manual

indices are grey until the system has
enough data to evaluate the driving
style.
Once sufficient data are available, the
indices will have 5 colours depending
on the evaluation: dark green (very
good), light green, yellow, orange and
red (very bad).
" Current route index" refers to the
entire value calculated in real time
based on the average of the described
indices. It represents eco-friendliness of
the driving style: from 0 (low) to 100
(high).
In case of prolonged stops, the screen
will show the average indexes obtained
up to that moment (the " Average
Index") to later start recolouring the
indexes in real time when the car starts
moving again.
If you want to confirm the data
averages from the previous trip (by
"trip" a cycle of positioning the starting
device in MAR and later in STOP is
meant), select the graphic button "
Previous Route".
The details of the previous trip can also
be displayed by pressing the " Details"
button, in which journey duration (time
and mileage) and average speed will be
reported.
224

Trip data storage and transfer

The travel data can be saved in the
system memory and transferred via a
USB key that has been purposefully
configured or thanks to the App
Uconnect™LIVE. This allows you to
display the history of the collected data,
showing the complete analysis of the
trip data and of your driving style.
More information is available on the
www.driveuconnect.eu site.
Do not remove the USB key or
uncouple the smart phone with the
App Uconnect™LIVE before the
system has downloaded the data,
because it could be lost. During the
transfer of data to the devices,
messages may appear on the radio
display to guide the user correctly
through the operation; follow these
instructions. These messages are
viewed only on the starter device in
STOP position and when a delay is set
in turning off the system. The data are
automatically transferred to the devices
when the engine is switched off.
Transferred data will be deleted from
the system memory in this manner. You
can decide to register the travel data or
not by pressing the graphic button "
Settings" and setting registration
activation and the mode of transfer to
USB or Cloud.
When the USB key memory is full, the
radio screen will show messages to that
effect.
When the eco:Drive™ data have not
been transferred to the USB key for a
while, the internal memory system
Uconnect™LIVE could become
saturated: in this case, follow the
recommendations provided by the
messages on the Uconnect™ screen.

my:Car

my:Car lets you always have the car's
health status under control.
The my:Car application is capable of
detecting malfunctioning in real time
and lets the driver know about the
expiry of maintenance coupons,
To interact with the application, press
the graphic button "my:Car": on the
screen there is a section "care:Index"
where all the detailed information on the
car's status will be shown. Pressing the
graphic button "Active signalling" you
can see (if there are any) the details of
the fault detected on the car which has
caused a warning light to go on.
The car's status can be viewed on both
the www.driveuconnect.eu and via App
Uconnect™LIVE.