Selec-Terrain; Driving Mode Selection; 4Wd Low Mode Engagement/Release; 4Wd Low Mode Release - Jeep Renegade Owner's Handbook Manual

automatically activated as well. If the
4WD LOW button is pressed again, the
4WD LOCK function will be activated.
If, however, the 4WD LOCK button is
pressed again, both functions will be
deactivated.
The 4WD LOW function is
recommended for irregular and slippery
terrain only.
4WD LOW MODE
ENGAGEMENT/RELEASE
4WD LOW mode engagement
With vehicle at a standstill, ignition
device in MAR position or with engine
on, move the gear lever to position D
(Drive), R (Reverse) or N (Neutral) and
press the 4WD LOW button.
On some versions, with mode engaged,
the display shows "4WD LOW". The
LED on the Selec-Terrain™ device
may flash until the end of the
engagement.

4WD LOW mode release

The release can occur at any speed
ranging from 0 to 120 km/h.
On some versions, "4WD LOW" on the
display switches off at the end of the
release procedure.
In this case, the LED on the 4WD LOW
button is off.
IMPORTANT
42) The correct operation of the 4WD
function depends on the tyres: all of them
must have the same size, the same type
and the same circumference. Using tyres
with different sizes has negative effects on
the gear change and damages the
components of the transmission.
43) Do not drive at speeds exceeding those
that the road conditions allow for.

SELEC-TERRAIN

DRIVING MODE
SELECTION
Turn knob A fig 105 to select the
wished mode.
105
Changing mode is not possible when
the vehicle speed is over 120 km/h.
AUTO (Automatic): the 4WD mode
with continuous and automatic
operation can be used while driving on
J0A0153C
121