Hazard Warning Lights; Replacing A Bulb; Emergency Braking - Jeep Renegade Owner's Handbook Manual

HAZARD WARNING
LIGHTS
CONTROL
Press button fig 126 to switch the lights
on/off.
When the hazard warning lights are on,
the and warning lights flash.
126
The use of hazard warning lights is
governed by the highway code of the
country you are driving in: comply with
legal requirements.

Emergency braking

In the event of an emergency braking
the hazard warning lights switch on
automatically as well as warning lights
and in the instrument panel.
The lights switch off automatically when
emergency braking ceases.
140

REPLACING A BULB

138) 139) 140) 59)
GENERAL
INSTRUCTIONS
Before replacing a bulb check the
contacts for oxidation;
replace blown bulbs with others of
the same type and power;
after replacing a headlight bulb,
always check its alignment;
when a light is not working, check
that the corresponding fuse is intact
before replacing the bulb. For the
location of fuses, refer to the paragraph
"If a fuse blows" in this chapter.
J0A0050C
When the weather is cold or damp or
after heavy rain or washing, the surface
of headlights or rear lights may steam
up and/or form drops of condensation
on the inside. This is a natural
phenomenon due to the difference in
temperature and humidity between the
inside and the outside of the glass
which does not indicate a fault and
does not compromise the normal
operation of lighting devices. The mist
disappears quickly when the lights are
turned on, starting from the centre of
the diffuser, extending progressively
towards the edges.