Jeep Renegade Owner's Handbook Manual page 161

compressor is in position 0 (off), start
the engine, insert the plug into the
luggage compartment power socket or
on central tunnel and switch on the
compressor by bringing the switch to
position I (on);
inflate the tyre to the pressure
indicated in the "Wheels" paragraph
(see "Technical data" chapter). In order
to obtain a more precise reading, check
the pressure value on pressure gauge B
with the compressor off;
if after five minutes it is still
impossible to reach at least 1.8 bar,
disengage the compressor from the
valve and power socket, then move the
vehicle forwards by approx. ten metres
in order to distribute the sealing fluid
inside the tyre evenly, then repeat the
inflation operation;
if after this operation you still cannot
reach at least 1.8 bar after 5 minutes
from switching on the compressor, do
not resume driving but contact a Jeep
Dealership;
after having driven for about 10
minutes, stop and re-check the tyre
pressure; remember to engage the
electric parking brake;
if a pressure value of at least 1.8 bar
is detected, restore the correct pressure
(with engine running and electric
parking brake), resume driving
immediately and drive with great care to
a Jeep Dealership.
WARNING
154) Punctures on the sides of the tire may
not be repaired. Do not use the TireKit if
the tyre was damaged as a result of being
used when underinflated.
155) Wear the protective gloves provided
with the TireKit.
156) Apply the adhesive label where it can
be easily seen by the driver as a reminder
that the tyre has been treated with the
TireKit. Drive carefully, particularly on
bends. Do not exceed 80 km/h. Avoid
sudden acceleration or braking.
157) If the pressure falls below 1.8 bar, do
not drive any further: the TireKit cannot
guarantee proper seal because the tyre is
too damaged. Contact a Jeep Dealership.
158) You must always indicate that the tyre
was repaired using the TireKit. Give the
booklet to the technicians who will be
handling the tyre that was treated using the
TireKit.
159) Repairs are not possible in the case of
damage to the wheel rim (bad groove
distortion causing air loss). Do not remove
foreign bodies (screws or nails) from the
tyre.
160) Never operate the compressor for
longer than 20 consecutive minutes. Risk
of overheating. The TireKit is not suitable
for definitive repairs, so the repaired tyres
may only be used temporarily.
161) The information required by current
regulations, regarding the chemical
substances for the protection of human
health and the environment and on the
safe use of the sealing fluid, are on the
packaging label. Compliance with the
indications on the label is an essential
condition to ensure the safety and the
effectiveness of the product. Remember to
carefully read the label before use; the user
of the product is responsible for any
damages caused by improper use. The
sealing fluid has an expiry date. Replace
the bottle if the sealant has expired.
IMPORTANT
62) In the event of a puncture caused by
foreign bodies, the kit may be used to
repair tyres showing damage on the tread
or shoulder up to max. 4 mm diameter.
IMPORTANT
3) Dispose of the bottle and the sealant
liquid properly. Have them disposed of in
compliance with national and local
regulations.
159