Display Of Traffic Information - Garmin GI 275 Pilot's Manual

Hazard Avoidance

DISPLAY OF TRAFFIC INFORMATION

Traffic information can be displayed on various pages. For more information on traffic
overlay options on map pages, and which unit configurations offer map pages, see the Map
Options discussion in the Navigation Section. For more information on displaying SVT-Traffic,
see the Additional Features section.
When traffic is detected, a 'TFC' annunciation will be displayed on each page. If configured
as a Standby ADI or an MFD, the 'Traffic' Page will be available. The 'Traffic' Page is the
principal page for viewing traffic information. Traffic data in relation to the aircraft' s current
position and altitude can be displayed. Orientation on this page is always heading up unless
there is no valid heading. The range may be adjusted by selecting the Range Button and using
the Inner Knob to zoom in or out.
Traffic source and mode information will be displayed on the outer edge of the display on
the 'Traffic' Page. The following table lists the different information fields that can be displayed.
Traffic Source
TIS-A
ADS-B
TIS-B
TAS
TCAS
152
Information Displayed on the 'Traffic' Page
- Traffic annunciations
- Orientation
- Range setting
- Traffic Information Banner
- Altitude Filter setting
- ADS-B Application Information
- Other Traffic Source mode (If configured)
- Traffic motion information
- Orientation
- Range Setting
- Target Selection Button
- Traffic Information Banner
- Altitude Filter setting
- ADS-B Status (If configured)
- Traffic Source mode
- Traffic motion information
- Orientation
- Range setting
- Target Selection Button
'Traffic' Page Information
Garmin GI 275 Pilot's Guide 190-02246-01 Rev. A