Getting Started; System Requirements; Package Contents; Software Driver Installation - ST STM32 User Manual

UM0722
5

Getting started

5.1

System requirements

In order to use the STM32 performance line USB demonstration kit with the Microsoft
®
Windows
98, Windows Millennium or Windows 2000 must be installed on your PC.
The version of the Windows OS installed on your PC may be checked by clicking the
"System" icon in the Control Panel.
5.2

Package contents

The STM32 performance line USB demonstration kit includes the following items:
Hardware content
●
One STM32 controller board with USB and I
card board.
●
One soldered STM32F103RET6 ARM-based 32-bit microcontroller device (LQFP64
package). It embeds Flash memory allowing 10 thousands reprogramming cycles. (The
min. value of the endurance = 10 Kcycles). The STM32F103RET6 is delivered already
programmed with the demonstration firmware.
Software content
●
STM32 Design Firmware Update (DFU) firmware
● STM32 DFU application that offers PC USB demonstration kit functionality
Documentation
●
STM32F103, TS4657IQT, TS2012IQT, TS4962IQT, TS472IQT datasheets
●
PCB production data
●
STM32F103 and audio devices flyers
●
This user manual UM0722
5.3

Software driver installation

The following steps are required to install the software driver of the USB Audio Device Class
device:
1. Connect the STM32 performance line USB demonstration kit to your PC/laptop USB
port and let the Windows recognize the Audio Device Class device
2. There is no need for any particular user action, just follow installation process and
acknowledge default Audio Device Class device driver to operating system once
requested. At the end of the installation a new Sound controller appears in the Device
Manager window as shown in
This new USB audio device becomes the main audio output for time being.
www.BDTIC.com/ST
operating system, a recent version of Windows, such as Windows XP, Windows
Doc ID 15867 Rev 1
2
S audio connector + one TS4657 audio
Figure 3.
Getting started
®
9/46