Brother DCP-T520W Online User's Manual page 339

Error Message
Jam D MP Tray
Jam E Inside/MP
Repeat Jam E In/MP
Low Temperature
Media is Full.
No Caller ID
No Device
No File
No Paper Fed Again
No Paper Fed MPTray
No Paper Fed Tray 1
Cause
The paper guides are not set to the
correct paper size.
The paper is jammed in the machine.
The paper guides are not set to the
correct paper size.
The room temperature is too low.
The USB flash drive you are using does
not have enough free space to scan the
document.
There is no incoming call history. You did
not receive calls or you have not
subscribed to the Caller ID service from
your telephone company.
When configuring the Wi-Fi Direct
network, the Brother machine cannot find
your mobile device.
The USB flash drive in the media drive
does not contain a .JPG file.
Paper dust has accumulated on the
surface of the paper pick-up rollers.
The machine is out of paper or paper is
not correctly loaded in the MP tray.
The machine is out of paper or paper is
not correctly loaded in the paper tray.
The Jam Clear Cover is not closed
correctly.
Action
Make sure the paper guides are set to the
correct paper size.
Gently remove the jammed paper.
See Related Information: Paper is
Jammed Inside and in the Multi-purpose
Tray (Paper Jam/Jam E Inside/MP).
Make sure the paper guides are set to the
correct paper size.
After warming the room, allow the
machine to warm up to room temperature.
Try again when the machine has warmed
up.
Delete unused files from your USB flash
drive to free some space, and then try
again.
To use the Caller ID feature, contact your
telephone company.
See Related Information: Caller ID.
• Make sure your machine and mobile
device are in the Wi-Fi Direct mode.
• Move the mobile device closer to your
Brother machine.
• Move your Brother machine and the
mobile device to an obstruction-free
area.
• If you are manually configuring the Wi-
Fi Direct network, make sure you have
entered the correct password.
• If your mobile device has a
configuration page for how to obtain
an IP address, make sure the IP
address of your mobile device has
been configured via DHCP.
Reinsert the correct USB flash drive in the
slot.
Clean the paper pick-up rollers.
See Related Information: Clean the Paper
Pick-up Rollers.
Do one of the following:
• Refill the MP tray, and then press c.
• Remove and reload the paper, and
then press c.
See Related Information: Load Paper in
the Multi-purpose Tray (MP Tray).
Do one of the following:
• Refill the paper tray, and then press c.
• Remove and reload the paper, and
then press c.
See Related Information: Load Paper.
Make sure the Jam Clear Cover is closed
evenly at both ends.
See Related Information: Printer Jam or
Paper Jam.
333