Mounting The Front Panel - Hanseatic HGTI6082E127735BS User Manual

Page EN-32 Installation and connection

Mounting the front panel

You can mount a front panel on the appliance
door which matches your kitchen. The front
panel must not exceed a weight of 5 kg.
1. Hold the front panel against the appliance
door such that the lower side of the front
panel is flush with the adjoining kitchen
cupboards.
2. Measure the distance between the front
panel and the control panel.
(b)
3. A gap of 5 mm to 25 mm can be offset
with the 5 trim strips supplied (b). Remove
the required number of trim strips from
the block. To do so, move the trim strip
vigorously but without using tools.
4. If you only need one trim strip, saw off the
four feet that stick out, clamp
the moulding under the con-
trol panel and secure it using
both countersunk screws (l).
Continue with Step 7.
5. If you need more than one trim strip, turn
the lower moulding and push it onto the
other mouldings. This hides the feet and
makes the surfaces flat.
6. If you
– need two trim strips, secure these using
both countersunk screws (l).
– need three trim strips, secure these us-
ing both countersunk screws (m).
– need four to five trim strips, secure these
using both countersunk screws (n).
(f)
7. Pull apart the two pairs of Velcro
straps (f).
8. Remove the protective film from the same
type of Velcro strap.
(f)
9. With the protective film removed, stick
the Velcro straps (f) onto the middle of
the recessed areas on the appliance
door.
10. Cut the positions of the Velcro straps out
of the drilling template.
11. Cut the number of trim strips used off the
drilling template.
12. Lay the supplied drilling template on the
reverse side of the front panel in such
a way that the drilling template and the
front panel are flush at the top.
(f)