Test Run - Hanseatic HGTI6082E127735BS User Manual

Test run

It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the de-
vice functions perfectly. Carry out this test run
when the dishwasher is empty and without
any dishwasher detergent.
1. Open the tap completely.
2. Close the appliance door.
3. Press the "On/Off" button
the appliance on.
You will hear a signal tone and all LEDs will
illuminate briefly.
The "ECO" programme indicator LED (6)
soon lights up.
4. Press the "Programme selection" but-
ton P (9) repeatedly until the programme
indicator LED lights up.
5. Start the cycle with the "Start/Pause" but-
ton (10).
The programme begins after a few sec-
onds.
6. Ensure that no water is coming out and
no unusual sounds can be heard.
7. When the programme is finished, an
acoustic signal will sound.
Switch the appliance off using the "On/
Off" button (1).
8. Slightly open the door to allow the moist
air to escape.
9. Close the tap.
If no water has escaped and no unusual nois-
es have been heard, the appliance is ready
for operation and you can now load it with
dishes.
Installation and connection
(1) to switch
Page EN-35