Error Indicators - Hanseatic HGTI6082E127735BS User Manual

Problem
The indicator is illu-
minated, although dish-
washer salt has been
added.
The water is not running
or it is running only very
slowly.
The water is not running
off or only very slowly.
The dishwasher is not
watertight.
The dishwasher can be
switched on/off, but not
cannot be operated.
The dishwasher cannot
be operated.

Error indicators

Code
flashing rapidly
It takes too long for the
water to fill up
flashing rapidly
Water overflow
( (The indicators and
flash quickly)
Possible cause
The dishwasher salt is
clumpy.
There is a kink in the inlet
hose.
The water tap is not properly
on.
The filters are blocked.
The outlet hose is kinked, has
been extended or is hanging
too high up/too low.
The door seal is defective.
The outlet hose or the inlet
hose is defective.
The dishwasher can only be
operated when the door is
closed.
The buttons are locked.
Solution
Turn the water tap on completely.
Arrange the inlet hose properly so that it is not kinked (see "Con-
necting the inlet hose" on page EN-29).
The water pressure is too low. The tap may not be on fully. Ensure
that the water pressure is correct (see "Technical specifications" on
page EN-41).
Switch off the tap. Find the gap in the seal (or have someone find
it) and repair the leak (or have it repaired).
Required temperature not reached: Malfunction of the heating ele-
ment
Troubleshooting table
Solution
Stir the dishwasher salt using the
end of a spoon or similar.
Lay out the inlet hose in such a
manner that it is not kinked.
Turn the water tap on completely.
Clean the filters (see page EN-26).
Lay out the outlet hose in the prop-
er manner (see page EN-28).
Have the door seal replaced (see
"Service" on page EN-39).
Have the defective hose replaced
(see "Service" on page EN-39).
Close the door.
Unlock the buttons (see "Button
lock" on page EN-23).
Page EN-37