Storage; Device Care - h/p/cosmos Arsalis Gaitway 3D Service Manual

gaitway-3D Service manual
Ref.:TM-MAN-0005-ARS
 Never put containers with liquid on the device as this may cause electric shock or
short circuit when the liquid is spilled.
More information on transport and installation for the gaitway-3D
treadmill is available in the instructions for use of the h/p/cosmos
treadmill ergometer. Please refer to the manual available at the address
below:
http://www.h-p-cosmos.com/en/company/downloads.htm
3.4.

Storage

 Store the device at a temperature of -25 °C to +40 °C with relative humidity of 0 %
to 95 % non-condensing, air pressure of 700 to 1060 hPa (maximum 3000m
altitude).
3.5.

Device care

 In case of any detected and/or assumed malfunctions and/or defects
or unreadable safety labels, the device must be discontinued
immediately. The device must be marked accordingly and its
operation discontinued (e.g. by pulling the power plug and affixing a
warning/defect label on the power plug). The supplier and authorized
service personnel are to be informed in writing immediately.
 Connector caps have to be installed on unused connectors of the instrumentation
amplifier top panel.
 Damaged socket connections, wires and pressure control switches are to be
replaced immediately by trained and authorized personnel.
 Fluid entering into the device is to be removed immediately by the authorized
customer service and a safety check is to be performed.
More information on the gaitway-3D treadmill device care is available in
the instructions for use of the h/p/cosmos treadmill ergometer. Please
refer to the manual available at the address below:
http://www.h-p-cosmos.com/en/company/downloads.htm
Iss.: A Rev.: 9 Date: 07/12/2020 Page : 10