Table of Contents
Advertisement
gaitway-3D Service manual
Ref.:TM-MAN-0005-ARS
Seq.
Description
No.
5.
Remove the 4 feet of the treadmill.
12.2. Treadmill support assembly
Date:
Time:
Seq.
Description
No.
6.
Screw the load cells on left and right foot
plates. Sensor 1 on front left, clockwise
numbering, and cables on back side.
7.
Attach the cable glands with locknuts on the
4 Capteur-Mini3D-Case-Open. Let them
slide freely on the cable.
Iss.: A
Rev.: 9
Date: 07/12/2020
Test Step
Required/No
minal (incl.
tolerance)
Test Step
Required/No
minal (incl.
tolerance)
Torque =
50Nm
Page : 20
Measurements/Test Results
Measured/
Remarks/Calculations
Calculated
Name:
Measurements/Test Results
Measured/
Remarks/Calculations
Calculated
4x DIN7991-M12x40
Note: Ensure that each load cells is
tightened at its nominal torque on the
first mounting side before tightening the
second
damaging the insert on load cell support
part.
4x Capteur-Mini3D-Case-Open
mounting
side,
to
avoid
Pass/
No
pass
Pass/
No
pass
Advertisement
Table of Contents
