The Up/ Down Program; The Up/ Down Mode Screen - Pro Mach Orion SENTRY System Manual

Sentry by Orion
Semi-Automatic Stretch Wrapping Machine
System Operation
Figure 3 - 14
The Up/ Down Mode
Screen
Page 3-10

The Up/ Down Program

Up/ Down mode will wrap the number of top wraps chosen in the parameters previously
described, then wrap the bottom wraps chosen in the parameters previously described and
repeat this process for the number entered in the Up and Down Num parameter. The cycle
will then end. The operator must then sever the wrap between the carriage and the load
and remove the load with a forklift or pallet jack (with optional ramp.)
1. On the Program Screen, press 1 to choose the Up/ Down program to run.
2. Press 0 or the green Program Execute button to start the Up/ Down cycle. The table,
up, and down indicators will show when the table is running and when the carriage is
moving up or down. While running this program, you may also choose the following:
A. Press +/- to pause the wrap cycle. The carriage will remain at the location it was at
when the machine was paused. Press 0 or the green Program Execute button to
resume the current cycle.
B. Press CLR to stop the wrap cycle. The carriage will move down to the start point.
C. You may leave the Up/Down screen displayed if you are going to wrap multiple
loads. If not, press ESC when the cycle is complete to choose a new program.
Orion
Revision 2.8
27 August 2014