Sentry by Orion
Semi-Automatic Stretch Wrapping Machine
Troubleshooting
PROBLEM
The Carriage Continues Too
Far Past the Top of the Load
Continual Film Breakage
Page 4-2
Table 4-1. Troubleshooting Charts (Continued)
POSSIBLE CAUSE
•
The photocell delay setting found on
the Top Wraps Modification Screen
is set too high.
•
Film tension is set too high.
•
Bad or old film.
Revision 2.8
27 August 2014
SOLUTION
•
Decrease the photocell delay.
•
Decrease the film tension
potentiometer knob.
•
Replace the film spool.
Orion