Table of Contents
Advertisement
Sentry by Orion
Semi-Automatic Stretch Wrapping Machine
Introduction and Safety
System Safety Recommendations
Page 1-4
Safeguarding personnel that operate and/or maintain automated equipment is the primary
consideration. Because it is very dangerous to enter the operating space (work envelope)
of a machine during operation, adequate safeguards must be in place and safety precau-
tions must be observed.
The following general precautions are recommended for all personnel who perform sys-
tem operation or maintenance.
•
Do lockout-tagout procedures whenever you do maintenance and repair work.
•
All personnel who repair, maintain, or operate the equipment need to know the loca-
tion of all EMERGENCY STOP buttons.
•
Do not operate the equipment with any of the safety guards removed.
•
Do not wear neckties, loose clothing, or long loose-hanging hair around any equip-
ment.
•
Observe and follow the DANGER, WARNING, and CAUTION messages throughout
this manual, in vendor manuals, and displayed on the equipment.
•
Personnel should attend all available safety and operational training courses.
•
Personnel should know and follow the recommended safety procedures whenever
they must enter the packaging systems motion area.
•
Personnel should not enter the packaging system while control power is "ON".
•
Personnel should not power up the system if someone is on the system.
•
The system should be powered down when not in use.
•
Personnel should pay special attention to all the posted warnings and cautions located
on any devices. Observe all safety and/or precautionary steps and procedures when
working with the system.
•
Personnel should keep the system clean to make it easier to spot hazards.
Orion
Revision 2.8
27 August 2014
Advertisement
Table of Contents
