Pro Mach Orion SENTRY System Manual page 28

Sentry by Orion
Semi-Automatic Stretch Wrapping Machine
System Operation
BUTTON
TURNTABLE SPEED
ADJ
CARRIAGE LIFT SPEED
ADJUST
FILM FEED SPEED
ADJUST
CYCLE STOP
POWER INDICATOR
PROGRAM EXECUTE
BUTTON
E-STOP
POWER ON/ OFF
SWITCH
ESC
ALM
DIRECTIONAL ARROW
SET
ENT
NUMERIC KEYPAD
Page 3-2
Table 3-1. The Control Panel Button/ Knob Descriptions
Turn this potentiometer knob toward (+) to increase the turntable speed and toward
(-) to decrease the turntable speed for any of the programs you are executing. This
can be adjusted "on the fly" while the machine is in cycle.
Turn this potentiometer knob toward (+) to increase the carriage up and down speed
and toward (-) to decrease the carriage up down speed for any of the programs you
are executing. This can be adjusted "on the fly" while the machine is in cycle.
Turn this potentiometer knob toward (+) to increase the film feed tension and toward
(-) to decrease the film tension for any of the programs you are executing. This can
be adjusted "on the fly" while the machine is in cycle. Adjusting too much tension in
relation to the turntable speed could break the film.
Press this button to bring the machine to a controlled stop. The machine does not
lose control power when a cycle stop is initiated.
This light is illuminated when machine power is present.
Press this button to execute the program selected. To select a program, go to (2) pro-
gram and select a program. The machine will not start unless a program is currently
being viewed on the LCD screen. For instance, pressing this button while on the
Menu screen will not start the machine.
Press this button to stop the machine immediately.
Turn this main power switch to the on position to turn on power to the machine.
Turn it to the off position to turn off power. Turn off power when the machine is not
in use.
Pres ESC to escape the currently displayed screen. The Menu screen is the top level
screen. Pressing ESC while executing a program will stop the machine. Always let
the machine run a complete cycle unless there is an emergency situation.
This button is not implemented on this model.
Use the directional arrows to adjust settings on the LCD screen.
Press set to highlight settings on the LCD screen. Highlighted settings are adjustable
with either the numeric keypad or up and down arrows.
Press ENT to confirm a setting. When making parameter adjustments, pressing ESC
without first pressing ENT will not save the setting.
Use the numeric keypad to enter parameters or make selections on the LCD screen.
DESCRIPTION
Orion
Revision 2.8
27 August 2014