Quick BTQ1403012 User Manual page 29

POS. DESCRIPTION
1 Motor mounting screw
2 Motor mounting washer
3A Motor 3KW 12V
3B Motor 3KW 24V
3C Motor 4KW 12V
3D Motor 4KW 24V
4 Even tension device
5 Half-joint
6 Motor flange
7 Gearbox gasket
8 O-Ring
9 Gearleg
10 Propeller drive pin
11 Key
12 Propeller
13 Propeller mounting nut
14 Anode tip
15 Anode tip mounting screw
16 Washer
17 Gearleg mounting screw
18A Reversing contactor unit 150A 12V ERBTQ1215000
18B Reversing contactor unit 150A 24V ERBTQ2415000
19 Clamp reversing contactor unit
20 Grower Ø4 stainless steel
21 Screw
22 Washer
23 Reversing contactor unit
mounting screw
24 Negative reversing contactor
25 Command wire
26 Screw
27 Carter reversing contactor unit
28 Fasteners carter reversing
contactor
29 Motor contact type A
30 Motor contact type B
BOW THRUSTER BTQ140 - BTQ185 IT GB - REV002C
CODE
MBV1025MXCEO
MBR10X000000
Quick
EMFEL3012000
ant to the sea environment: In any case, it is indispensable
EMFEL3024000
to periodically remove salt deposits that form on the outer
EMFEL4012000
EMFEL4024000 surfaces to avoid corrosions and consequent system inef-
PVPR43000000
ficiency
MMSGM1100000
SGMMEM185000
Dismantle once a year, following the points below:
PGRDEL185000
• Keep the propeller (11) and the gearleg (9) clean.
PGR031250000
• Paint the propeller and the gearleg with anti-vegetative
MREM18500000
paint before each season.
MBSC05025A00
MBH050515F00
PVEL18500000
MBD12MXET000
MMANBTQ18500
MBV0625MXCE0
MBR08X000000
• Check the zinc anode (14) frequently.
MBV0850MXCE0
• Replace the zinc anode before every season or when it is
more than half consumed.
• After any maintenance, make sure that the bolts (17) that
MMSTBTQ15000
lock the flange (6) to the gearleg (9) are well tightened.
MBG04X000000
• After every maintenance, make sure that the propeller
MBV0510MXCE0
(11) is well tightened and that the bolts (1) locking the
MBR051510X00
electric motor (3) are tight.
MBV0510MXCE0
• Make sure that all electrical connections are clean and
SAECCCBTQNG0
firmly fixed (24, 25, 29 and 30).
SAECCCBTQCM0
• Make sure that the batteries are in good condition.
MBV0420MXVEP
PCCCBTQA0000
PBD04STPN000
ECBRABTQA000
ECBRABTQB000
MAINTENANCE
WARNING: make sure that the power supply to the
electric motor is not switched on when maintenance
operations are carried out.
® Bow Thrusters are made in materials that are resist-
:
WARNING do not paint the zinc anode (14), the seal-
ings and the propeller shafts. Be careful not to allow
paint to penetrate in the "tracks" of the gearleg (9) in
which the propeller hub moves.
GB
29