Quick BTQ1403012 User Manual page 27

POS. DESCRIPTION
1 Motor mounting screw
2 Motor mounting washer
3A Motor 1,5KW 12V
3B Motor 2,2KW 12V
4 Half-joint
5 Half-joint
6 Even tension device
7 Motor flange
8 Gearbox gasket
9 O-Ring
10 Gearleg
11 Propeller drive pin
12 Key
13 Propeller
14 Propeller mounting nut
15 Anode tip
16 Anode tip mounting screw
17 Grower Ø6 stainless steel
18 Gearleg mounting screw
19 Reversing contactor unit 150A 12V ERBTQ1215000
20 Clamp
21 Grower Ø4 stainless steel
22 Screw
23 Washer
24 Screw
25 Negative reversing contactor
26 Command wire
27 Pin
28 Carter reversing contactor unit PCCCBTQA0000
29 Fasteners carter reversing
contactor
30 Motor contact type C - dx
31 Motor contact type C - sx
32 Motor contact type D
BOW THRUSTER BTQ140 - BTQ185 IT GB - REV002C
CODE
MBV0825MXCE0
MBR08X000000
Quick
EMFEL1512000
ant to the sea environment: In any case, it is indispensable
EMFEL2212000
to periodically remove salt deposits that form on the outer
MMSGM1100000
MMSGM1400000 surfaces to avoid corrosions and consequent system inef-
PVPR43000000
ficiency.
SGMMEM140000
PGRDEL140000
Dismantle once a year, following the points below:
PGR021060000
• Keep the propeller (12) and the gearleg (10) clean.
MREM14000000
• Paint the propeller and the gearleg with anti-vegetative
MBSC04025A00
paint before each season.
MBH040415F00
PVEL14000000
MBD10MXET000
MMANBTQ14000
MBV0520MBCE0
MBR06X000000
MBV0640MXCE0
• Check the zinc anode (15) frequently.
• Replace the zinc anode before every season or when it is
MMSTBTQ15000
more than half consumed.
MBG04X000000
MBV0406MXCC0 • After any maintenance, make sure that the bolts (18) that
MBR051510X00
lock the flange (7) to the gearleg (10) are well tightened.
MBV0510MXCE0
• After every maintenance, make sure that the propeller
SAECCCBTQNG0
(12) is well tightened and that the bolts (1) locking the
SAECCCBTQCM0
electric motor (3) are tight.
MBV0420MXVEP
• Make sure that all electrical connections are clean and
firmly fixed (25, 26, 30, 31 and 32).
• Make sure that the batteries are in good condition.
PBD04STPN000
ECBRABTQC000
ECBRABTQC000
ECBRABTQD000
MAINTENANCE
WARNING: make sure that the power supply to the
electric motor is not switched on when maintenance
operations are carried out.
® Bow Thrusters are made in materials that are resist-
:
WARNING do not paint the zinc anode (15), the seal-
ings and the propeller shaft Be careful not to allow
paint to penetrate in the "tracks" of the gearleg (10)
in which the propeller hub moves.
GB
27