Table 2-1: Commands Supported By The Preselector - Tektronix 2706 Instruction Manual

GPIB Common and Device Commands
2706 RF Preselector
The Preselector is now ready for remote operation. You can operate it by using a
controller to send commands described in the following GPIB Common and
Device Commands section.
Refer to Appendix B, Using the GPIB Interface, and your controller's operating
manual for detailed information about sending GPIB commands.
This section briefly lists the common and device commands used to operate the
Preselector from a remote GPIB controller. Appendix B, Using the GPIB
Interface, contains a detailed, alphabetical listing of these commands and
provides an example program.
Common commands (preceded by an asterisk in Table 2.1) are used by all
devices that meet IEEE Std. 488.2-1987. Device commands (listed without an
asterisk in Table 2.1) are specific to the Preselector and are defined only in this
manual. The Preselector has two device commands: B and STS?.
NOTE. You do not need to use timing commands such as *WAI, *OPC, and
*OPC? with the Preselector. For example, the *WAI command normally prevents
a GPIB device from executing commands until all pending operations finish.
Because the Preselector executes commands sequentially, the *WAI command
always continues immediately.
Table 2–1: Commands Supported by the Preselector
Full Command Title
Name
B<NR1> Select band filter (NR1 stands for an integer from 0 to 8)
*CLS Clear Status
*ESE and *ESE? Standard Event Status Enable
*ESR? Standard Event Status Register Query
*IDN? Identification Query
*IST? Individual Status Query
*OPC and *OPC? Operation Complete
*PRE and *PRE? Parallel Poll Register Enable
*RST Reset
*SRE and *SRE? Service Request Enable
*STB? Read Status Byte
STS? Status Selected Band Query
Using the Preselector
2–3