Figure 1-2: The Preselector's Rear Panel - Tektronix 2706 Instruction Manual

Rf preselector

Table of Contents

Introduction

Rear Panel

The Preselector's Rear Panel

Figure 1–2:

What you Need to Use the Preselector

1–2

The Preselector rear panel has these connectors and switches:

H IEEE STD 488 PORT – this connects the Preselector to a controller.

H ADDRESS switch – this selects the GPIB address for the Preselector.

H POWER – this plugs the Preselector into the AC power source

(90–250 VAC, 48–63 Hz).

To use the Preselector, you need the following:

H an RF signal source, such as an antenna or test device (Chapter 4, "Applica-

tions," describes example setups)

H a spectrum analyzer, such as the Tektronix 271X–, 278X–, or 279X–Series

(or equivalent)

H two RF connecting cables with type N connectors or adapters

If you will operate the Preselector remotely, you will also need the following:

H an IEEE STD 488 GPIB 24-pin cable with a D-type shell (Tektronix part

number 012–0991–00)

H an IEEE–488 GPIB controller, or an IBM PC/AT or compatible 80386 (or

better) personal computer with a National Instruments PCII/IIA type card

and communications drivers

H a copy of the Tektronix S26EM12 Commercial EMI Test Software (optional)

2706 RF Preselector

Table of Contents