Following Installation (Cable) - 3M DBI-SALA RoofSafe Anchor User Instruction Manual

3M™ DBI-SALA
Following Installation
Section 17.0
17.1 Completed Installations
On completion of the installation, the installer should provide as a minimum:
• A certificate commissioning the system (See 17.2)
• A System Label (see 17.3)
• Detailed information on the system design, including end loads, cable deflection, details of fabrications used in the system design,
maximum number of users, specific restrictions regarding user equipment and testing requirements
• A User Instruction Manual
• A serial number for the installation
• A rescue plan that covers any emergencies that may arise during use of the system. (This may be provided as an additional service
for which the installer is entitled to charge.)
17.2 Certificate
This should contain a minimum of:
• The location of the installation
• A unique identification number
• The number and length of systems
• The maximum number of users per span and per system
• The length and type of lanyards
• The installation date
• The date of the next necessary service
• The name and contact details of the installation company
• The name of the installation engineer and / or supervisor.
A representative of the installation company should sign the certificate.
17.3 System Label
The System Label should be located at the entrance point to the System. It should contain the following information:
• The maximum number of users per span and per system
• The maximum lanyard length and type of lanyard specified
• Installation date and details of the installation company
• Next service date
• Serial number of the system
• The minimum ground clearance
• Contact details of the manufacturing company.
17.4 Training
The 3M Fall Protection certified Installer should provide the end user with training on how to use the System and user equipment.
This may involve an additional cost.
Form No: 5903917 Rev: D Form No: 5903917 Rev: D
RoofSafe Anchor and Cable System
®
23