Using The System (Cable) - 3M DBI-SALA RoofSafe Anchor User Instruction Manual

3M™ DBI-SALA
Using The System
Section 16.0
16.1 User Equipment
Always wear a full body harness. The user should attach their shock absorbing lanyard to the rear 'D' ring of the harness.
This prevents the lanyard getting in the way during use. Always ensure that the locking mechanism of the carabiner is properly
closed before proceeding and get a second person to check this and all other attachments. In the event of a fall all equipment should
be removed from service and inspected by a 3M Fall Protection certified Installer before it can be possibly returned to service.
16.2 Accessing the System
Access to the System should be gained from a position of safety. If necessary the user should use other safety equipment,
such as a twin-tailed lanyard, to facilitate safe access to the attachment area.
16.3 Attaching to the System
The UniGrab is designed in such a way that it is possible to enter the system at any point. They're carried out as follows:
To open 8 mm UniGrab, slide top tab
to the left and lift upwards.
Attach the 2001000 carabiner and lanyard.
Ensure that carabiner number matches
number engraved around the slot of the
8 mm UniGrab.
Form No: 5903917 Rev: D Form No: 5903917 Rev: D
RoofSafe Anchor and Cable System
®
01
Place the 8 mm UniGrab onto the cable
and close by moving top tab downwards
and to the right.
04
You are now safely attached to the cable
system. To remove the 8 mm UniGrab
from the cable follow the previous steps
in reverse order from 5-1.
02
Ensure that holes are aligned.
WARNING! Only use 3M Fall Protection's
2001000 carabiner with the 8 mm UniGrab
to ensure system integrity.
N.B: Remember
to inspect your
05
Section 7 continued on next page.
03
PPE before
each use!
21