K2, C, YM Print Head Uncapping/Capping
While the machine is idle, the K2, C, and YM print heads (1) on the bottom of the
carriage unit are capped and sealed by the print head caps (2).
At the start of the next print job, the lift motor (3) rotates forward and lowers the
K2, C, and YM caps to uncap the K2, C, YM print heads.
The rotating lift actuator (4) (mounted on a shaft with a cam driven by the lift
motor) and lift sensor (5) control the lowering of the three print caps.
The caps rest on the absorbent cap pads (6) while they are down.
D124
124
Detailed Descriptions