Ricoh D124 Detailed Descriptions Manual page 100

5. The paper is pushed into the machine through the open nip of the registration
roller (and out the back of the machine) until the front right corner is at the
alignment mark [B]. The bypass sensor switches on.
6. Next, the operator lowers the paper holding lever, and then closes the front cover.
 The paper transport fan switches on.
 The vertical motor switches on and reverse feeds the paper 30 mm and then
switches off.
 The carriage unit moves to the right so the DRESS sensor can check for skew,
detect the right edge and right edge of the paper (so the machine can calculate
paper width), and detect the leading edge of the paper.
 The vertical motor switches on and reverse feeds the paper to the registration
standby position and then switches off.
7. A message on the operation panel asks the operator to confirm that the paper type
is correct.
8. After the operator confirms that the paper type is correct, the print job starts.
9. At the end of the job, a message prompts the operator to remove the paper.
There is one restriction on the use of bypass feed. Nothing will print within 18 or 21
mm of the trailing edge.
Normally, the margin at the trailing edge is 18 mm, except when printing with color in
the following cases:
Special
Special
Matte Film
Tracing Paper
D124
Media
Standard
Quality
Quality
Quality
94
Print Mode
Detailed Descriptions