Esd Warning; Revision History - Connect Tech Quark NGX004 User Manual

ESD Warning

REVISION HISTORY

Revision Date
0.00 2020-02-19
0.01 2020-02-27
0.02 2020-06-15
0.03 2020-07-13
0.04 2020-12-15
Document: CTIM-00084
Revision: 0.04
Electronic components and circuits are sensitive to
ElectroStatic Discharge (ESD). When handling any circuit
board assemblies including Connect Tech COM Express
carrier assemblies, it is recommended that ESD safety
precautions be observed. ESD safe best practices include,
but are not limited to:
• Leaving circuit boards in their antistatic
packaging until they are ready to be installed.
Using a grounded wrist strap when handling
•
circuit boards, at a minimum you should touch a
grounded metal object to dissipate any static
charge that may be present on you.
• Only handling circuit boards in ESD safe areas,
which may include ESD floor and table mats,
wrist strap stations and ESD safe lab coats.
• Avoiding handling circuit boards in carpeted
areas.
• Try to handle the board by the edges, avoiding
contact with components.
Changes
Preliminary Release
Cable details added
Orderable part numbers added
CAN Bus
• Product feature description updated
• I/O Header notes updated
USB Type C
• Power capability note added
Supported camera list removed
Weight details added
CTI thermal solutions for Xavier NX added
Mechanical Drawings added
Feature Table - GPIO / PWM description updated
Product Feature and Specification:
Added RTC Battery Support
•
Updated Template
Updated Current Consumption Details
Updated Typical Installation instructions
Page 5 of 24
Quark Carrier
Users Guide
www.connecttech.com
Date: 2020-12-15