Balluff BML-S1H1 Series User Manual page 30

BML-S1H1/2-B/S6 _ C-M3 _ A-D0-KA _ _ , _ -S284
Absolute Magnetically Coded Position Measuring System
3
Construction and function
3.1 Construction
~49
Fig. 3-1: BML-S1H1/2-...-KA_ _,_-S284, construction
When installing, observe the tightening torque
(see section 4.2 on page 11).
Measured value
max.
23
Left
Rear
8
Right
Start of Active
magnetic measuring surface
tape 23
Start of Active
magnetic measuring surface
tape
Fig. 3-2: BML-S1H1-..., positioning and measuring range
1) Note the orientation of the master track label!
(Note: Bonded magnetic tape may not be removed, not even
partially.)
2) Magnetic tape is not included in the scope of delivery.
3) If the magnetic tape is to be shortened, the length of the
magnetic tape must exceed the measuring range by this
value. Only shorten magnetic tape on the "end of magnetic
tape" side (see Fig. 3-2). Observe the notes in the magnetic
tape user's guide!
www.balluff.com
Cable length
2
10
1)
mastertrack
7 6
2
BML-M0_-A3_-A_-M0008-A
BML-M0_-A3_-A_-M0028-C
mastertrack
BML-M0_-A3_-A_-M0006-A
BML-M0_-A3_-A_-M0026-C
BML-M0_-A3_-A_-M0106-F
Sensor head
2×M4
40
Measuring range
2)
Measuring range
6
12 14
(shown without
plug)
Active measuring surface
4±2
End of magnetic tape
3)
4±2
End of magnetic tape
english
3)
7