■Wave output parameter setting processing program example
The following figure shows an example of a program that is used to partially change the parameter settings of the wave output
function read from the file register (ZR) or a CSV file. When no change is made, this program is not required.
After changing the settings, enable the settings with the operating condition setting request program. ( Page 49 Operating
condition setting request processing program example)
(647) Sets CH1 Wave output start/stop request to Wave output stop request (0).
(674) Turns on Wave output setting FB start flag and changes the value of the wave output function in the buffer memory.
(1276)Turns off Wave output setting FB start flag.
7 OPERATION EXAMPLE
48
7.3 Program Example (Wave Output Mode)