Table of Contents
Advertisement
Chapter 2 Install Your Product
2.1 Plug in Signals
Connect signals to the product (ensure all devices are powered off first). Tighten connector screws/locks
where provided.
2.2 Plug in Main Power
Connect IEC cable to device and plug into wall socket. Turn on power at wall socket.
2.3 Turn on Your Product
Turn the power switch on the rear to ON position.
TST screen shows as below， meanwhile the device enter initializing state after that， the device will show
its input and output and system state.
User Manual
FLEX4ML
10
Advertisement
Table of Contents
